Posted by Dieter on October 27, 2002 at 11:16:54:
Well, I think the translation of this problem will be more difficult than the technical problem itself:
I want to mount a 48-mm-miniature-speedometer at the fork tube of a LS 650 model from 1997. (Adapters for this are offered by different shops.)
To avoid a strongly bowed spedo-shaft by using an (legthened) shaft form the gear-box (original transmission), I want to use a spedo-shaft-adapter (so called "right-angle-transmission" ???) placed at the front wheel like it is "normally" used by other bike models.
I think it must be possible, because there is a gap of approx. 30 mm between the end of the hub and the lower part of the fork tube at the right side of it.
Does anybody know, what kind of adapter (not necessarily produced by SUZUKI) can be used?
I know, there´ll be some additional changes necessary, especially concerning the hub, but the dimensions (transmission-range for a 19-inch-tire,width, diameter of adapter, diameter of front-wheel-valve) should be matching at least.
Dieter
DAS GANZE AUF DEUTSCH:
Ich möchte den Tank-Tacho bei einer 1997-er LS 650 gegen einen 48-mm-Tacho mit Befestigung am Gabelholm tauschen.
Nun möchte ich aber nicht die alte Tachowelle vom Getriebe kommend verlängern und mit viel Gebiege zum Tacho quälen, sondern einen Tachoantrieb vom Vorderrad via Tachowelle zu enem jenem zukünftig am Gabelholm befestigten Tacho haben.
Daher meine Frage:
Wer weiß, welcher Vorderrad-Tachoantrieb von welchem Serien-Modell (19-Zoll-Rad!) sich mit vergleichsweise wenig technischen Aufwand an das LS 650-Vorderrrand adaptieren lässt.
(Dass da ´nen paar Änderungen speziell an der Nabe erforderlich sind, ist mir schon klar, aber wenigstens die Abmessungen sollten weitestgehend stimmen (Breite, Durchmesser des Adapters und der Achsaufnahme, Breite.)
Dieter